The Program is a little more complicated than the Basic and Advance program. It still has the same ‘Communication Settings’, ‘Pump Status’, and ‘Commands’ areas described above. The ‘Multi-Steps’ area is different.

The pump software options include single pump, pump channel 1, pump channel 2, and cycle mode. Select single pump if the syringe pump you are using is not a dual syringe pump. Choose pump channel 1 or 2 to communicate with that respective syringe. Cycle mode will cycle between the two pumps.

Mode sets the mode for the syringe pump. The options in this enum are blank, basic and programmable. Select blank if the syringe pump is not a dual syringe pump. Select basic or programmable to send commands with those modes for the Fusion 4000.

Units allows you to change the units used in the commands and responses. Diameter sets the inner diameter of the syringe.

The area labelled ‘Step parameters’ allows you to define a step. This is done by setting the volume to be pumped, the rate at which to pump, and a delay after the step. Using the buttons right of this section you can set the parameters as the current step shown in the Current Step control, or add the step before the current step or add the step after the current step. Clicking remove step removes the current

    Have any questions or comments about this article? Fill out the form below and we'll get back to you as soon as possible!

    Privacy & Terms

    By choosing "I agree" below you agree to Chemyx Inc Terms of Service. You Also agree to our Privacy Policy, which describes how we process your information.