How To Control The Delay Time For Infuse & Withdraw In Cycle Mode – Fusion 4000

Follow these steps to control the delay time between infuse and withdraw in cycle mode for the Chemyx Fusion 4000 Multi-Channel Syringe Pump.

1. Go to the menu:

2. Press the following commands on the key pad to the right:   . ⌫ 6  5  4

Note: the “” is the bottom right of the keypad.

3. Change “Early Sec” New Value to zero: 0 (see red section below)

Note: smaller number will decrease the time and larger number will increase the time delay.

4. Exit by pressing the X in the top right corner of the screen.

    Have any questions or comments about this article? Fill out the form below and we'll get back to you as soon as possible!

    Privacy & Terms

    By choosing "I agree" below you agree to Chemyx Inc Terms of Service. You Also agree to our Privacy Policy, which describes how we process your information.