Python Program for Chemyx Syringe Pumps

Download for Fusion 100-X, Fusion 200-X and Fusion 6000-X

Chemyx Syringe Python Program

This program will allow you to start, pause, and stop the syringe pump channel.

Requirements

  • A computer running Python.
  • The computer must be equipped with a serial port or a USB port.
  • RS232 DB9 straight-through cable or USB-to-USB cable

Getting Started

  1. Make sure that your computer meets the requirements.
  2. Connect the pump to the computer.
  3. Run the program
  4. Start programming the syringe pump using Python.

Warranty and Support:

This software and driver are provided by Chemyx “as is” and any express or implied warranties, including, but not limited to, the implied warranty of merchantability and fitness for a particular purpose are disclaimed. In no event shall Chemyx or any Contributor be liable for any direct, indirect, incidental, special exemplary, or consequential damage (including, but not limited to, procurement of substitute goods or services, loss of use, data, or profits; or business interruption). However caused and on any theory of liability, whether in contract, strict liability, or tort (including negligence or otherwise) arising in any way out of the use of the provided driver or software, even if advised of the possibility of such damage.

Chemyx does not warrant that the functions contained in the provided driver and software will meet any requirement or that the operation of the software will be error free.

The software and driver described here are freeware to control Chemyx syringe pumps.

Chemyx does not provide technical support for the program and software described here.

    Have any questions or comments about this article? Fill out the form below and we'll get back to you as soon as possible!

    Privacy & Terms

    By choosing "I agree" below you agree to Chemyx Inc Terms of Service. You Also agree to our Privacy Policy, which describes how we process your information.