Application: Using Chemyx Fusion 4000 & 6000 Syringe Pumps In Controlling A Soft Materials 3D Printer

2.2 Voltage Conversion

The RAMBo has four rows of pins used to send and receive UART serial commands. However, the serial port on the Fusion 6000 syringe pump is an RS232, which sends and receives signals at a different voltage level than the RAMBo. To solve this problem, two RS232 to TTL converters are used (BC71075, NKC Electronics). The converters, shown in Figure 2, are built around a MAX232 chip, which uses a capacitive voltage generator to transform the 5V signal from the RAMBo into a 15V signal that the RS232 port can recognize [4]. A more detailed schematic of the converters can be found in Figure A3 in the appendix.

These two converters connect two of the four rows of serial pins in the RAMBo to the two extruders. Hypothetically, if one were to add more extruders for builds that required additional printing materials, a third and fourth extruder could be added by purchasing two additional converters and using the remaining two serial pins.

 

Figure 2: Wiring diagram showing how the Fusion 6000 syringe pumps, the RAMBo serial pins, and the UV LED communicate. Red wires are power, blue wires are ground, orange wires are TX, pink wires are RX, and black wires are DB9 connectors.

By the Department of Industrial and Enterprise Systems Engineering

Read the full article here.

Contact Chemyx

Contact our support team about Chemyx Syringe Pump products & services. We have experienced engineers to help you choose the right syringe pump product for your application!

CONTACT